MUET logo

Numerical Modelling of Factors Critical to Slope Stability with Plaxis 2D

Authors

  • Muhammad Rehan Hakro

    Department of Civil Engineering Mehran University of Engineering & Technology, Sindh Pakistan
    Author

  • Imtiaz Ali Hakro

    Institute of Petroleum & Natural Gas Engineering Mehran UET Jamshoro
    Author

  • Rabia Soomro

    Department of Civil Engineering, Mehran University of Engineering and Technology Shaheed Zulfiqar Ali Bhutto Campus, Khairpur Mir's, Sindh, Pakistan.
    Author

  • Faisal Ahmed Rajper

    Executive Engineer, Irrigation Department Government of Sindh
    Author

  • Shehnaz Hakro

    PhD Scholar Center for Environmental Sciences, University of Sindh Jamshoro
    Author

DOI:

https://doi.org/10.22581/muet1982.0377

Keywords:

Slope, Critical Factors, Rainfall, Loading, Piles, Factor of safety (FOS)

Abstract

Slope instability is among the primary issues in geotechnical engineering that can result in loss of life and property. This study assessed slope stability by Factor of Safety (FOS) in FEM Plaxis 2D software with different geotechnical and hydrological conditions. The Mohr–Coulomb model is used to predict behaviour of soil and the input parameters determined in the laboratory. Mohr-Coulomb constitutive model is typically more preferred than the Drucker Prager model for slope stability analysis since the soil strength is a key factor controlling slope stability. To determine the geotechnical parameters of soil samples were obtained from each slope segment. In the laboratory, soil samples were evaluated for their strength properties, soil type, size distribution, permeability, etc. The factor of safety (FOS) is determined based on various factors that contribute to slope instability. The parameters for each slope are changed, and the safety factor is determined for each step. The FOS was 2 at the load of 25 kPa and reduced to 1.4 with load of 100 kPa soil. The effect of the footing distance to the edge of the slope is represented by w/x. As the ratio decreased, an increase in the factor of safety value was observed. The FOS decreased from 2.38 to 1.76 with a rainfall duration of 20 days. This study shows that rainfall significantly reduces matric suction in soils at shallow depths, leading to a decrease in shear strength and an increased risk of shallow failures. Additionally, a non-linear relationship between setback distance and FOS was observed, emphasizing the importance of conservative design practices. Finally, the study confirms that pile installation significantly enhances slope stability, with longer piles generally leading to higher FOS. However, optimal pile length and location are highly dependent on site-specific conditions.

Downloads

References

[1] T. Stacey, Xianbin, Y., Armstrong, R., and G. Keyter, "New slope stability considerations for deep open pit mines," Journal of the Southern African Institute of Mining and Metallurgy, vol. 103, no. 6, pp. 373–389, 2003.

[2] M. Delic, A. Nuric, S. Nuric, and V. Radulovic, "Specifying the influence of landfill coal mine ‘Dubrave’ on the surrounding terrain," Proceedings 41th IOCMM, Mining and Metallurgy Institute Bor and University of Belgrade Technical Faculty Bor, pp. 293–298, 2009.

[3] A. Nuric, S. Nuric, L. Kricak, and R. Husagic, "Numerical methods in analysis of slope stability," International Journal of Science and Engineering Investigations, vol. 2, no. 14, pp. 41–48, 2013.

[4] A. Anand, R. Acharyya, and A. Dey, "Footings on unreinforced slopes: Numerical modelling using GeoStudio."

[5] A. W. Bishop, "The use of the slip circle in the stability analysis of slopes," Geotechnique, vol. 5, no. 1, pp. 7–17, 1955.

[6] Y. M. Cheng, T. Lansivaara, and W. Wei, "Two-dimensional slope stability analysis by limit equilibrium and strength reduction methods," Computers and Geotechnics, vol. 34, no. 3, pp. 137–150, 2007.

[7] D. Griffiths, "Computation of collapse loads in geomechanics by finite elements," Ingenieur-Archiv, vol. 59, no. 3, pp. 237–244, 1989.

[8] D. Griffiths and P. Lane, "Slope stability analysis by finite elements," Geotechnique, vol. 49, no. 3, pp. 387–403, 1999.

[9] M. Huang and C.-Q. Jia, "Strength reduction FEM in stability analysis of soil slopes subjected to transient unsaturated seepage," Computers and Geotechnics, vol. 36, no. 1–2, pp. 93–101, 2009.

[10] E. Dawson, W. Roth, and A. Drescher, "Slope stability analysis by strength reduction," Geotechnique, vol. 49, no. 6, pp. 835–840, 1999.

[11] F. Cai and K. Ugai, "Numerical analysis of rainfall effects on slope stability," International Journal of Geomechanics, vol. 4, no. 2, pp. 69–78, 2004.

[12] F. Cai, K. Ugai, and T. Hagiwara, "Base stability of circular excavations in soft clay," Journal of Geotechnical and Geoenvironmental Engineering, vol. 128, no. 8, pp. 702–706, 2002.

[13] F. Cai and K. Ugai, "Reinforcing mechanism of anchors in slopes: a numerical comparison of results of LEM and FEM," International Journal for Numerical and Analytical Methods in Geomechanics, vol. 27, no. 7, pp. 549–564, 2003.

[14] W. Alkasawneh, A. I. H. Malkawi, J. H. Nusairat, and N. Albataineh, "A comparative study of various commercially available programs in slope stability analysis," Computers and Geotechnics, vol. 35, no. 3, pp. 428–435, 2008.

[15] X. Zhou and H. Cheng, "Analysis of stability of three-dimensional slopes using the rigorous limit equilibrium method," Engineering Geology, vol. 160, pp. 21–33, 2013.

[16] G. F. deWolfe, D. Griffiths, and J. Huang, "Probabilistic and deterministic slope stability analysis by random finite elements," in GeoTrends: The Progress of Geological and Geotechnical Engineering in Colorado at the Cusp of a New Decade, 2011, pp. 91–111.

[17] I. Hamdhan and H. Schweiger, "Finite element method–based analysis of an unsaturated soil slope subjected to rainfall infiltration," International Journal of Geomechanics, vol. 13, no. 5, pp. 653–658, 2013.

[18] I. N. Hamdhan, "Slope Stability Analysis with the Finite Element Method."

[19] R. H. Brooks and A. T. Corey, "Hydraulic properties of porous media and their relation to drainage design," Transactions of the ASAE, vol. 7, no. 1, pp. 26–28, 1964.

[20] D. G. Fredlund and A. Xing, "Equations for the soil-water characteristic curve," Canadian Geotechnical Journal, vol. 31, no. 4, pp. 521–532, 1994.

[21] C. McKee and A. Bumb, "Flow-testing coalbed methane production wells in the presence of water and gas," SPE Formation Evaluation, vol. 2, no. 4, pp. 599–608, 1987.

[22] S. A. Tan, S. Tjahyono, and K. Oo, "Simplified plane-strain modeling of stone-column reinforced ground," Journal of Geotechnical and Geoenvironmental Engineering, vol. 134, no. 2, pp. 185–194, 2008.

[23] A. Zewdu, "Modeling the slope of embankment dam during static and dynamic stability analysis: A case study of Koga dam, Ethiopia," Modeling Earth Systems and Environment, vol. 6, pp. 1963–1979, 2020.

[24] A. R. Mardookhpour, "Retrofitting shear stability and fixing clay soils in farm conduits by geotextiles," Pakistan Journal of Agricultural Sciences, vol. 47, no. 3, pp. 287–291, 2010.

[25] M. S. Keskin and M. Laman, "Model studies of bearing capacity of strip footing on sand slope," KSCE Journal of Civil Engineering, vol. 17, no. 4, pp. 699-711, 2013.

[26] T. Matsui and K.-C. San, "Finite element slope stability analysis by shear strength reduction technique," Soils and foundations, vol. 32, no. 1, pp. 59-70, 1992.

Published

2025-10-28

Issue

Vol. 44 No. 4 (2025): October Issue

Section

Articles

License

Copyright (c) 2025 Mehran University Research Journal of Engineering and Technology

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

How to Cite

Numerical Modelling of Factors Critical to Slope Stability with Plaxis 2D. (2025). Mehran University Research Journal of Engineering and Technology, 44(4), 143-150. https://doi.org/10.22581/muet1982.0377

Similar Articles

31-39 of 39

You may also start an advanced similarity search for this article.